Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 250
intf-type cr4 autoneg, keepalive
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 250 highlights
www.dell.com | support.dell.com FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in VLANs. IP ACLs are supported. Refer to Chapter 6, Access Control Lists (ACL). Related Commands interface interface loopback interface null interface port-channel show vlan shutdown tagged untagged Configures a physical interface. Configures a loopback interface. Configures a null interface. Configures a port channel group. Displays the current VLAN configuration on the switch. Disables/Enables the VLAN. Adds a Layer 2 interface to a VLAN as a tagged interface. Adds a Layer 2 interface to a VLAN as an untagged interface. intf-type cr4 autoneg Set the interface type as CR4 with auto-negotiation enabled. Syntax intf-type cr4 autoneg If intf-type cr4 autoneg is configured, use the no intf-type cr4 autoneg command to set the interface type as cr4 with autonegotiation disabled. Defaults Not configured Command Modes CONFIGURATION Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module If interface type is configured as CR4 with auto-negotiation enabled, then the peer should also be configured as CR4 with auto-negotiation. Many DAC cable link issues can be resolved by setting the interface type as CR4. Related Commands interface interface loopback interface null interface port-channel Configures a physical interface. Configures a loopback interface. Configures a null interface. Configures a port channel group. keepalive Syntax Send keepalive packets periodically to keep an interface alive when it is not transmitting data. keepalive [seconds] To stop sending keepalive packets, use the no keepalive command. 250 | Interfaces