Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 646
debug uplink-state-group, interface
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 646 highlights
www.dell.com | support.dell.com Parameters interface interface uplink-state-group group-id Specifies one or more downstream interfaces. For interface, enter one of the following interface types: 10-Gigabit Ethernet: tengigabitethernet {slot/port |slot/port-range} 40-Gigabit Ethernet: fortygigabitethernet {slot/port |slot/port-range} Port channel: port-channel {1-512 | port-channel-range} Where port-range and port-channel-range specify a range of ports separated by a dash (-) and/or individual ports/port channels in any order; for example: tengigabitethernet 1/1-2,5,9,11-12 port-channel 1-3,5 A comma is required to separate each port and port-range entry. Re-enables all UFD-disabled downstream interfaces in the group. Valid group-id values are 1 to 16. Command Modes EXEC Mode Command History Related Commands Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module downstream upstream uplink-state-group Assigns a port or port-channel to the uplink-state group as a downstream interface. Assigns a port or port-channel to the uplink-state group as an upstream interface. Creates an uplink-state group and enable the tracking of upstream links. debug uplink-state-group Enable debug messages for events related to a specified uplink-state group or all groups. Syntax debug uplink-state-group [group-id] To turn off debugging event messages, use the no debug uplink-state-group [group-id] command. Parameters group-id Enables debugging on the specified uplink-state group. Valid group-id values are 1 to 16. Defaults Command Modes Command History Related Commands none EXEC Privilege Version 8.3.16.1 clear ufd-disable Introduced on MXL 10/40GbE Switch IO Module Re-enables downstream interfaces that are in a UFD-disabled error state. 646 | Uplink Failure Detection (UFD)