Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 326
iscsi target port, show iscsi
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 326 highlights
www.dell.com | support.dell.com iscsi target port Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication will be monitored. Syntax iscsi target port tcp-port-1[tcp-port-2...tcp-port-16][address ip-address] To remove the configured iSCSI target ports or IP addresses, use the no iscsi target port command. Parameters tcp-port-2...tcpport-16 ip-address Enter the tcp-port number of the iSCSI target ports. The tcp-port-n is the TCP port number or a list of TCP port numbers on which the iSCSI target listens to requests. Separate port numbers with a comma. Default: 860, 3260. (OPTIONAL) Enter the ip-address that the iSCSI will monitor. The ip-address specifies the IP address of the iSCSI target. Defaults 860, 3260. Command Modes CONFIGURATION Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information You can configure up to 16 target TCP ports on the switch in one command or multiple commands. When you use the no iscsi target port command, and the TCP port to be deleted is one bound to a specific IP address, the IP address value must be included in the command. show iscsi Display the currently configured iSCSI settings. Syntax show iscsi Command Mode EXEC EXEC Privilege Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module 326 | iSCSI Optimization