Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 657

dei mark Set the DEI value on egress according to the color currently assigned to the packet. Syntax dei mark {green | yellow} {0 | 1} Parameters 0 | 1 green | yellow Enter the bit value you want to map to a color. Choose a color: • Green: High priority packets that are the least preferred to be dropped. • Yellow: Lower priority packets that are treated as best-effort. Defaults All the packets on egress are marked with DEI 0. Command Mode INTERFACE Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage You must first enable DEI for this configuration to take effect. Information Related Commands dei enable Enables DEI. member Assign a Stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack compatible command in its configuration. Syntax member interface To remove an interface from a Stackable VLAN, use the no member interface command. Parameters interface Enter the following keywords and slot/port or number information: • For a Port Channel interface, enter the keyword port-channel followed by a number: Range: 1 to 128 • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabyte Ethernet interface, enter the keyword fortyGigE followed by the slot/ port information. Defaults Not configured. Command Mode conf-if-vl--stack Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage You must enable stackable VLAN (using the vlan-stack compatible command) on the VLAN prior to Information adding a member to the VLAN. VLAN Stacking | 657