Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 247
Multiple Range Bulk Configuration Gigabit Ethernet and Ten Gigabit
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 247 highlights
Example Figure 14-13. Interface Range prompt Overlapping Port Ranges FTOS(conf)#interface range tengig 2/1 - 11 , tengig 2/1 - 23 FTOS(conf-if-range-tengig-2/1-23# Only VLAN and port-channel interfaces created using the interface vlan and interface port-channel commands can be used in the interface range command. Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or port-channel interfaces that are not displayed in the show running-config command cannot be used with the bulk configuration feature of the interface range command. You cannot create virtual interfaces (VLAN, Port-channel) using the interface range command. Note: If a range has VLAN, physical, and port-channel interfaces, only commands related to physical interfaces can be bulk configured. To configure commands specific to VLAN or port-channel, only those respective interfaces should be configured in a particular range. Example Figure 14-14 is an example of a single range bulk configuration. Figure 14-14. Single Range Bulk Configuration FTOS(conf)# interface range tengigabitethernet 5/1 - 23 FTOS(conf-if-range)# no shutdown FTOS(conf-if-range)# Figure 14-15 shows how to use commas to add different interface types to the range enabling all Ten Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet interfaces 1/1 and 1/2. Example Figure 14-15. Multiple Range Bulk Configuration Gigabit Ethernet and Ten Gigabit Ethernet FTOS(conf-if)# interface range tengigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2 FTOS(conf-if-range)# no shutdown FTOS(conf-if-range)# Figure 14-16 shows how to use commas to add VLAN and port-channel interfaces to the range. Example Figure 14-16. Multiple Range Bulk Configuration with VLAN and port channel FTOS(conf-if)# interface range tengigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2, Vlan 2 - 100 , Port 1 - 25 FTOS(conf-if-range)# no shutdown FTOS(conf-if-range)# Related Commands interface port-channel interface vlan show config (from INTERFACE RANGE mode) show range interface range macro (define) Configures a port channel group. Configures a VLAN interface. Shows the bulk configuration interfaces. Shows the bulk configuration ranges. Defines a macro for an interface-range. Interfaces | 247