Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 502

www.dell.com | support.dell.com Related Commands default-information originate Generates a default route for RIP traffic. redistribute ospf Redistribute routing information from an OSPF process. Syntax redistribute ospf process-id [match external {1 | 2} | match internal | metric metric-value] [route-map map-name] To disable redistribution, use the no redistribute ospf process-id [match external {1 | 2} | match internal | metric metric-value] [route-map map-name] command. Parameters process-id match external {1 | 2} match internal metric metric-value route-map map-name Enter a number that corresponds to the OSPF process ID to be redistributed. Range: 1 to 65355. (OPTIONAL) Enter the keywords match external followed by the numbers 1 or 2 to indicated that external 1 routes or external 2 routes should be redistributed. (OPTIONAL) Enter the keywords match internal to indicate that internal routes should be redistributed. (OPTIONAL) Enter the keyword metric followed by a number as the metric value. Range: 0 to 16 (OPTIONAL) Enter the keyword route-map followed by the name of a configured route map. Defaults Not configured. Command Modes ROUTER RIP Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module router rip Enter ROUTER RIP mode to configure and enable RIP. Syntax router rip To disable RIP, use the no router rip command. Defaults Disabled. Command Modes CONFIGURATION Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module To enable RIP, you must assign a network address using the network command. 502 | Routing Information Protocol (RIP)