Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 464
rate shape, service-class dynamic dot1p, dot1p, Queue ID
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 464 highlights
www.dell.com | support.dell.com Related Commands rate-police Police traffic output as part of the designated policy. rate shape Shape the traffic output on the selected interface. Syntax rate shape [kbps] rate [burst-KB] Parameters kbps rate burst-KB Enter this keyword to specify the rate shape in Kilobits per second (Kbps). On MXL Switch. make the following value a multiple of 64. The default granularity is Megabits per second (Mbps). Range: 0-40000000 (Kbps) Enter the outgoing rate in multiples of 10 Mbps. Range: 10 to 10000 (OPTIONAL) Enter a number as the burst size in KB. Range: 0 to 10000 Default: 50 Defaults Granularity for rate is Mbps unless the kbps option is used. Command Modes INTERFACE Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Related Commands rate-shape Shapes the traffic output as part of the designated policy. service-class dynamic dot1p Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes INTERFACE mode entries. Syntax service-class dynamic dot1p To return to the default setting, use the no service-class dynamic dot1p command. Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class dynamic dot1p command. Then the default mapping is as follows: Table 25-1. Default dot1p to Queue Mapping dot1p 0 1 2 Queue ID 0 0 0 464 | Quality of Service (QoS)