Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 169
priority-group qos-policy, priority-list
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 169 highlights
Related Commands priority-list set-pgid Configure the 802.1p priorities for an ETS output policy. Configure the priority-group. priority-group qos-policy Associate the 802.1p priority traffic in a priority group with the ETS configuration in a QoS output policy. Syntax priority-group group-name qos-policy ets-policy-name To remove the 802.1p priority group, use the no priority-group qos-policy command. Parameters group-name ets-policy-name Enter the group name of the 802.1p priority group. Maximum: 32 characters. Enter the ETS policy name. Defaults none Command Modes DCB OUTPUT POLICY Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage The ETS configuration associated with 802.1p priority traffic in a DCB output policy is used in DCBX Information negotiation with ETS peers. If you disable ETS in an output policy applied to an interface using the no ets mode on command, any previously configured QoS settings at the interface or global level take effect. If QoS settings are configured at the interface or global level and in an output policy map (service-policy output command), the QoS configuration in the output policy takes precedence. Related Commands dcb-output dcb-policy output Create a DCB output policy. Apply the output policy. priority-list Configure the 802.1p priorities for the traffic on which you want to apply an ETS output policy. Syntax priority-list value To remove the priority list, use the no priority-list command. Parameters value Enter the priority list value. Separate priority values with a comma; specify a priority range with a dash; for example, priority-list 3,5-7. The value range is 0 to 7. Defaults none Data Center Bridging | 169