Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 573
sflow enable Global, sflow enable Interface
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 573 highlights
As part of the sFlow-MIB, if the simple network management protocol (SNMP) request originates from a configured collector, FTOS returns the corresponding configured agent IP in management information base (MIB) requests. FTOS checks to ensure that two entries are not configured for the same collector IP with a different agent IP. Should that happen, FTOS generates the following error: %Error: Different agent-addr attempted for an existing collector sflow enable (Global) Enable sFlow globally. Syntax sflow enable To disable sFlow, use the no sflow enable command. Defaults sFlow is disabled by default Command Modes Command History Usage Information CONFIGURATION Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module In addition to this command, sFlow needs to be enabled on individual interfaces where you want sFlow sampling. Related Commands sflow enable (Interface) Enables sFlow on interfaces. sflow enable (Interface) Enable sFlow on Interfaces. Syntax sflow enable To disable sFlow, use the no sflow enable command. Defaults sFlow is disabled by default on all interfaces Command Modes INTERFACE Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information When you enable sFlow on an interface, flow sampling is done on any traffic going out of the interface. Note: After a physical port is a member of a LAG, it inherits the sFlow configuration from the LAG port. Related Commands sflow enable (Global) Turns sFlow on globally sFlow | 573