Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 471

qos-policy-output wred-profile Creates an output QOS-policy on the router. Creates a WRED profile. match ip dscp Use a differentiated services code point (DSCP) value as a match criteria. Syntax match ip dscp dscp-list [set-ip-dscp value] To remove a DSCP value as a match criteria, use the no match ip dscp dscp-list [[multicast] set-ip-dscp value] command. Parameters dscp-list set-ip-dscp value Enter the IP DSCP value(s) that is to be the match criteria. Separate values by commas - no spaces (1,2,3) or indicate a list of values separated by a hyphen (1-3). Range: 0 to 63 (OPTIONAL) Enter the keyword set-ip-dscp followed by the IP DSCP value. The matched traffic will be marked with the DSCP value. Range: 0 to 63 Defaults none Command Modes CLASS-MAP CONFIGURATION (config-class-map) Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage You must enter the class-map command in order to access this command. After the class map is Information identified, you can configure the match criteria. The match ip dscp and match ip precedence commands are mutually exclusive. Up to 64 IP DSCP values can be matched in one match statement. For example, to indicate IP DCSP values 0, 1, 2, 3, 4, 5, 6, 7, enter either the command match ip dscp 0,1,2,3,4,5,6,7 or match ip dscp 0-7. Note: Only one of the IP DSCP values must be a successful match criterion, not all of the specified IP DSCP values need to match. Related Commands class-map Identifies the class map. match ip precedence Use IP precedence values as a match criteria. Syntax match ip precedence ip-precedence-list [set-ip-dscp value] To remove IP precedence as a match criteria, use the no match ip precedence ip-precedence-list [set-ip-dscp value] command. Quality of Service (QoS) | 471