Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 99

Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage The order option is relevant in the context of the Policy QoS feature only. For more information, refer Information to the Quality of Service (QoS) chapter of the FTOS Configuration Guide. In the MXL Switch, you can configure either count (packets) or count (bytes). However, for an ACL with multiple rules, you can configure some ACLs with count (packets) and others as count (bytes) at any given time. Related Commands ip access-list standard permit Configures a standard ACL. Configures a permit filter. ip access-list standard Create a standard IP access list (IP ACL) to filter based on IP address. Syntax ip access-list standard access-list-name Parameters access-list-name Enter a string up to 140 characters long as the ACL name. Defaults All IP access lists contain an implicit deny any, that is, if no match occurs, the packet is dropped. Command Modes CONFIGURATION Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module FTOS supports one ingress and one egress IP ACL per interface. The number of entries allowed per ACL is hardware-dependent. For detailed specification on entries allowed per ACL, refer to your switch documentation. Example Figure 6-4. ip access-list standard Command Example FTOS(conf)#ip access-list standard TestList FTOS(conf-std-nacl)# Related Commands ip access-list extended resequence access-list Creates an extended access list. Displays the current configuration. permit Configure a filter to permit packets from a specific source IP address to leave the switch. Syntax permit {source [mask] | any | host ip-address} [count [byte]] [dscp value] [order] To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. Access Control Lists (ACL) | 99