Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 404
passive-interface
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 404 highlights
www.dell.com | support.dell.com mask area-id Enter a network mask in /prefix format. (/x) Enter the OSPF area ID as either a decimal value or in a valid IP address. Decimal value range: 0 to 65535 IP address format: dotted decimal format A.B.C.D. Note: If the area ID is smaller than 65535, it will be converted to a decimal value. For example, if you use an area ID of 0.0.0.1, it will be converted to 1. Command Modes ROUTER OSPF Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module To enable OSPF on an interface, the network area command must include, in its range of addresses, the primary IP address of an interface. Note: An interface can be attached only to a single OSPF area. If you delete all the network area commands for Area 0, the show ip ospf command output will not list Area 0. passive-interface Suppress both receiving and sending routing updates on an interface. Syntax passive-interface {default | interface} To enable both the receiving and sending routing, enter the no passive-interface interface command. To return all OSPF interfaces (current and future) to active, enter the no passive-interface default command. Parameters default interface Enter the keyword default to make all OSPF interfaces (current and future) passive. Enter the following keywords and slot/port or number information: • For Port Channel groups, enter the keyword port-channel followed by a number: Range: 1-128 • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Command Modes ROUTER OSPF Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Although the passive interface will neither send nor receive routing updates, the network on that interface will still be included in OSPF updates sent via other interfaces. 404 | Open Shortest Path First (OSPFv2)