Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 132

www.dell.com | support.dell.com Route Map Commands When an access-list is created without any rule and then applied to an interface, ACL behavior reflects implicit permit. The following commands allow you to configure route maps and their redistribution criteria. • continue • description • match interface • match ip address • match ip next-hop • match ip route-source • match metric • match route-type • match tag • route-map • set automatic-tag • set metric • set metric-type • set tag • show config • show route-map continue Configure a route-map to go to a route-map entry with a higher sequence number. Syntax continue [sequence-number] Parameters sequence-number (OPTIONAL) Enter the route map sequence number. Range: 1 - 65535 Default: no sequence number Defaults Not Configured Command Modes ROUTE-MAP Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module The continue feature allows movement from one route-map entry to a specific route-map entry (the sequence number). If you do not specify the sequence number, the continue feature simply moves to the next sequence number (also known as an implied continue). If a match clause exists, the continue feature executes only after a successful match occurs. If there are no successful matches, continue is ignored. 132 | Access Control Lists (ACL)