Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 324
iscsi aging time, iscsi cos
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 324 highlights
www.dell.com | support.dell.com iscsi aging time Set the aging time for iSCSI sessions. Syntax iscsi aging time time To remove the iSCSI session aging time, use the no iscsi aging time command. Parameters time Enter the aging time for the iSCSI session. Valid values: 5 to 43,200 minutes. Defaults 10 minutes. Command Mode CONFIGURATION Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module iscsi cos Set the QoS policy that will be applied to the iSCSI flows. Syntax iscsi cos {enable | disable | dot1p vlan-priority-value [remark] | dscp dscp-value [remark]} To disable the QoS policy, use the no iscsi cos dscp command. Parameters enable disable dot1p vlan-priority-value dscp dscp-value remark Enter the keyword enable to allow the application of preferential QoS treatment to iSCSI traffic so that the iSCSI packets are scheduled in the switch with a dot1p priority 4 regardless of the VLAN priority tag in the packet. Default: iSCSI packets are handled with dotp1 priority 4 without remark. Enter the keyword disable to disable the application of preferential QoS treatment to iSCSI frames. Enter the dot1p value of the VLAN priority tag assigned to the incoming packets in an iSCSI session. The valid range is 0 to 7. Default: The dot1p value in ingress iSCSI frames is not changed and is used in iSCSI TLV advertisements if you did not enter the iscsi priority-bits command. Enter the DSCP value assigned to the incoming packets in an iSCSI session. The valid range is 0 to 63. Default: The DSCP value in ingress packets is not changed. Marks the incoming iSCSI packets with the configured dot1p or DSCP value when they egress to the switch. Default: The dot1and DSCP values in egress packets are not changed. Defaults Command Modes See above. CONFIGURATION Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module 324 | iSCSI Optimization