Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 585

Parameters notification-type notification-option Enter the type of notification from the list below: • ecfm - Notification of changes to ECFM • entity - Notification of changes to entity • envmon-Device notification when an environmental threshold is exceeded • eoam - Notification of changes to the EOAM state • ets - Notification of changes to the ets traps • fips - Notification of changes to the FIP snooping state • lacp - Notification of changes to the LACP state • pfc - Notification of changes to pfc traps • snmp - Notification of RFC 1157 traps. • stp - Notification of state change in Spanning Tree protocol (RFC 1493) • vrrp-Notification of state change in a VRRP group • xstp-Notification of state change in MSTP (802.1s), RSTP (802.1w), and PVST+ For the envmon notification-type, enter one of the following optional parameters: • temperature For the snmp notification-type, enter one of the following optional parameters: • authentication • coldstart • linkdown • linkup Defaults Not enabled. Command Modes CONFIGURATION Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information FTOS supports up to 16 SNMP trap receivers. If you do not configure this command, no traps controlled by this command are sent. If you do not specify a notification-type and notification-option, all traps are enabled. Related Commands snmp-server community Enables SNMP and set the community string. snmp-server engineID Configure name for both the local and remote SNMP engines on the router. Syntax snmp-server engineID [local engineID] [remote ip-address udp-port port-number engineID] To return to the default, use the no snmp-server engineID [local engineID] [remote ip-address udp-port port-number engineID] command. Simple Network Management Protocol (SNMP) and Syslog | 585