Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 432

www.dell.com | support.dell.com Parameters start-interval hold-interval max-interval Set the minimum interval between initial sending and resending the same LSA. Range: 0-600,000 milliseconds Set the next interval to send the same LSA. This is the time between sending the same LSA after the start-interval has been attempted. Range: 1-600,000 milliseconds Set the maximum amount of time the system waits before sending the LSA. Range: 1-600,000 milliseconds Defaults start-interval : 0 msec hold-interval : 5000 msec max-interval: 5000 msec Command Modes ROUTER OSPF Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module LSAs are sent after the start-interval and then after hold-interval until the maximum interval is reached. In throttling, exponential backoff is used when sending same LSA, so that the interval is multiplied until the maximum time is reached. For example, if the start-interval 5000 and hold-interval 1000 and max-interval 100,000, the LSA is sent at 5000 msec, then 1000 msec, then 2000 msec, them 4000 until 100,000 msec is reached. timers throttle lsa arrival Configure the LSA acceptance intervals. Syntax timers throttle lsa arrival arrival-time To return to the default, use the no timers throttle lsa command. Parameters arrival-time Set the interval between receiving the same LSA repeatedly, to allow sufficient time for the system to accept the LSA. Range: 0-600,000 milliseconds Defaults 1000 msec Command Modes ROUTER OSPF Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module 432 | Open Shortest Path First (OSPFv2)