Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 685

drops [unit 0-0 [port 1-56]] stack-port 33-56 unit 0-0 {counters | details | port-stats [detail] | register} Enter the drops keyword to display internal drops on the selected stack member. Optionally, use the unit keyword with 0 to select port-pipe 0, and then use port 1-56 to select a port on that port-pipe. Enter this keyword and a stacking port number to select a stacking port for which to display statistics. Identify the stack port number as you would to identify a 10G port that was in the same place in one of the rear modules. Note: You can identify stack port numbers by physical inspection of the rear modules. The numbering is the same as for the 10G ports. You can also inspect the output of the show system stack-ports command. Enter the unit keyword followed by 0 for port-pipe 0, and then enter one of the following keywords to troubleshoot errors on the selected port-pipe and to give status on why a port is not coming up to register level: counters, details, port-stats [detail], or register Defaults none Command Modes EXEC EXEC Privilege Command History Example 1 Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Figure 39-3. show hardware stack-unit phy-firmware-version Command Example FTOS#show hardware stack-unit 0 phy-firmware-version PortNumber Status Programmed Version SW Version 41 Present 01.06 01.06 42 Present 01.06 01.06 43 Present 01.06 01.06 44 Present 01.06 01.06 45 Present 01.06 01.06 46 Present 01.06 01.06 47 Present 01.06 01.06 48 Present 01.06 01.06 49 Not Present N/A N/A FTOS# Debugging and Diagnostics | 685