Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 59
show debugging, show environment,
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Command History Example Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Figure 4-11. show cpu-traffic-stats Command Example FTOS#show cpu-traffic-stats Processor : CP Received 100% traffic on TenGigabitEthernet 8/2 LLC:0, SNAP:0, IP:100, ARP:0, other:0 Unicast:100, Multicast:0, Broadcast:0 Total packets:100 FTOS# Usage Information Traffic statistics are sorted on a per-interface basis; the interface receiving the most traffic is displayed first. All CPU and port information is displayed unless a specific port or CPU is specified. Traffic information is displayed for router ports only; not for management interfaces. The traffic statistics are collected only after the debug cpu-traffic-stats command is executed; not from the system bootup. Note: After debugging is complete, use the no debug cpu-traffic-stats command to shut off traffic statistics collection. Related Commands debug cpu-traffic-stats Enables CPU traffic statistics for debugging. show debugging View a list of all enabled debugging processes. Syntax show debugging Command Mode EXEC Privilege Command History Example Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Figure 4-12. show debugging Command Example FTOS#show debug Generic IP: (Access List: test) IP packet debugging is on for (Access List: test) TenGigabitEthernet 0/16 ICMP packet debugging is on for TenGigabitEthernet 0/16 OSPF:1 OSPF packet debugging is on DHCP: DHCP debugging is on FTOS# show environment View system component status (for example, temperature, voltage). Syntax show environment [all | stack-unit unit-id] Control and Monitoring | 59