Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 651
uplink-state-group, show uplink-state-group Command Examples
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 651 highlights
Example Figure 36-3. show uplink-state-group Command Examples FTOS# show uplink-state-group Uplink State Group: 1 Uplink State Group: 3 Uplink State Group: 5 Uplink State Group: 6 Uplink State Group: 7 Uplink State Group: 16 Status: Enabled, Up Status: Enabled, Up Status: Enabled, Down Status: Enabled, Up Status: Enabled, Up Status: Disabled, Up FTOS# show uplink-state-group 16 Uplink State Group: 16 Status: Disabled, Up FTOS#show uplink-state-group detail (Up): Interface up (Dwn): Interface down (Dis): Interface disabled Uplink State Group : 1 Upstream Interfaces : Downstream Interfaces : Status: Enabled, Up Uplink State Group : 3 Status: Enabled, Up Upstream Interfaces : Te 0/46(Up) Te 0/47(Up) Downstream Interfaces : Te 13/0(Up) Te 13/1(Up) Te 13/3(Up) Te 13/5(Up) Te 13/6(Up) Uplink State Group : 5 Status: Enabled, Down Upstream Interfaces : Te 0/0(Dwn) Te 0/3(Dwn) Te 0/5(Dwn) Downstream Interfaces : Te 13/2(Dis) Te 13/4(Dis) Te 13/11(Dis) Te 13/12(Dis) Te 13/13(Dis) Te 13/14(Dis) Te 13/15(Dis) Uplink State Group : 6 Upstream Interfaces : Downstream Interfaces : Status: Enabled, Up Uplink State Group : 7 Upstream Interfaces : Downstream Interfaces : Status: Enabled, Up Uplink State Group : 16 Status: Disabled, Up Upstream Interfaces : Te 0/41(Dwn) Po 8(Dwn) Downstream Interfaces : Te 0/40(Dwn) Related Commands show running-config uplink-state-group uplink-state-group Displays the current configuration of one or more uplink-state groups. Creates an uplink-state group and enable the tracking of upstream links. uplink-state-group Create an uplink-state group and enable the tracking of upstream links on a switch/router. Syntax uplink-state-group group-id To delete an uplink-state group, use the no uplink-state-group group-id command. To disable upstream-link tracking without deleting the uplink-state group, use the no enable command in Uplink-State-Group Configuration mode. Parameters group-id Enter the ID number of an uplink-state group. Range: 1-16. Defaults none Command Modes CONFIGURATION Uplink Failure Detection (UFD) | 651