Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 285
show tdr tengigabitethernet Command Example, Table 14-12., TDR Test Status, Status
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 285 highlights
Parameters interface Enter the keyword TenGigabitEthernet followed by the slot/port information for the 100/1000 Ethernet interface. Defaults none Command Modes EXEC Command History Example Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Figure 14-44. show tdr tengigabitethernet Command Example FTOS#show tdr tengigabitethernet 10/47 Time since last test: 00:00:02 Pair A, Length: OK Status: Terminated Pair B, Length: 92 (+/- 1) meters, Status: Short Pair C, Length: 93 (+/- 1) meters, Status: Open Pair D, Length: 0 (+/- 1) meters, Status: Impedance Mismatch Table 14-12. TDR Test Status Status OK Status: Terminated Length: 92 (+/- 1) meters, Status: Shorted Length: 93 (+/- 1) meters, Status: Open Status: Impedance Mismatch Definition TDR test is complete, no fault is detected on the cable, and the test is terminated A short is detected on the cable. The location, in this example is 92 meters, of the short is accurate to plus or minus one meter. An opening is detected on the cable. The location, in this example is 93 meters, of the open is accurate to plus or minus one meter. There is an impedance mismatch in the cables. Usage Information Related Commands If the TDR test has not been run, an error messages is generated: %Error: Please run the TDR test first tdr-cable-test Runs the TDR test. Interfaces | 285