Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 283

Table 14-10. show interfaces port-channel Command Example Fields (continued) Field Output 0... Rate information... Time since... Description Displays the type and number of packets sent out the interface. This information is displayed over three lines. Displays the traffic rate information into and out of the interface. Traffic rate is displayed in bits and packets per second. Displays the time since the last change in the configuration of this interface. Figure 14-43. show interfaces port-channel brief Command Example FTOS#show int po 1 brief Codes: L - LACP Port-channel LAG Mode Status 1 L3 down FTOS# Uptime 00:00:00 Ports Te 0/16 (Down) Table 14-11. show interfaces port-channel brief Command Example Fields Field LAG Mode Status Uptime Ports (untitled) Description Lists the port channel number. Lists the mode: • L3 - for Layer 3 • L2 - for Layer 2 Displays the status of the port channel. • down - if the port channel is disabled (shutdown) • up - if the port channel is enabled (no shutdown) Displays the age of the port channel in hours:minutes:seconds. Lists the interfaces assigned to this port channel. Displays the status of the physical interfaces (up or down). In Layer 2 port channels, an * (asterisk) indicates which interface is the primary port of the port channel. The primary port sends out interface PDU. In Layer 3 port channels, the primary port is not indicated. Related Commands show lacp Displays the LACP matrix. Interfaces | 283