Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 311
show ip fib stack-unit
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 311 highlights
show ip fib stack-unit View all forwarding information base (FIB) entries. Syntax show ip fib stack-unit 0-5 [ip-address [mask] [longer-prefixes] | summary] Parameters 0-5 ip-address mask longer-prefixes summary Enter the stack unit ID, from 0 to 5. (OPTIONAL) Enter the IP address of the network destination to view only information on that destination. Enter the IP address in dotted decimal format (A.B.C.D). You must enter the mask in slash prefix format (/X). (OPTIONAL) Enter the keyword longer-prefixes to view all routes with a common prefix. (OPTIONAL) Enter the keyword summary to view the total number of prefixes in the FIB. Command Mode EXEC EXEC Privilege Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Example Figure 15-12. show ip fib stack-unit Command Example FTOS#show ip fib stack-unit 0 Destination Gateway First-Hop Mac-Addr Port VId EC 10.10.10.10/32 Direct, Nu 0 0.0.0.0 00:00:00:00:00:00 BLK HOLE 0 0 FTOS> Table 15-6. show ip fib stack-unit Command Example Fields Field Destination Gateway First-Hop Mac-Addr Port VId EC Description Lists the destination IP address. Displays either the word Direct and an interface for a directly connected route or the remote IP address to be used to forward the traffic. Displays the first hop IP address. Displays the MAC address. Displays the egress-port information. Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed. Displays the number of ECMP paths. Related Commands clear ip fib stack-unit Clears FIB entries on a specified stack unit. IPv4 Routing | 311