Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 78
undebug all, virtual-ip, write, IPv4 Command Example
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
www.dell.com | support.dell.com undebug all Disable all debug operations on the system. Syntax undebug all Defaults none Command Modes EXEC Privilege Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module virtual-ip Syntax Configure a virtual IP address for the active management interface. You can configure virtual addresses for IPv4 independently. virtual-ip {ipv4-address} Parameters {ipv4-address} Enter the IPv4 address (A.B.C.D) of the active management interface. Defaults none Command Modes CONFIGURATION Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Each time this command is issued, it replaces the previously configured address of the same family. The no virtual-ip command now takes an address/prefix-length argument, so that the desired address only is removed. If you use the no virtual-ip command without any specified address, the IPv4 virtual addresses are removed. Example Figure 4-33. virtual ip (IPv4) Command Example FTOS#virtual-ip 10.11.197.99/16 write Copy the current configuration to either the startup-configuration file or the terminal. Syntax write {memory | terminal} Parameters memory terminal Enter the keyword memory to copy the current running configuration to the startup configuration file. This command is similar to the copy running-config startup-config command. Enter the keyword terminal to copy the current running configuration to the terminal. This command is similar to the show running-config command. 78 | Control and Monitoring