Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 170
qos-policy-output ets, scheduler
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
www.dell.com | support.dell.com Command Modes PRIORITY-GROUP Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information By default: • All 802.1p priorities are grouped in priority group 0. • 100% of the port bandwidth is assigned to priority group 0. The complete bandwidth is equally assigned to each priority class so that each class has 12-13%. Related Commands priority-group qos-policy set-pgid Create an ETS priority group. Configure the priority-group. qos-policy-output ets Create a QoS output policy to configure the ETS bandwidth allocation and scheduling for priority traffic. Syntax qos-policy-output policy-name ets To remove the QoS output policy, use the no qos-policy-output ets command. Parameters policy-name Enter the policy name. Maximum: 32 characters. Command Modes Command History CONFIGURATION Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information If an error occurs in an ETS output-policy configuration, the configuration is ignored and the scheduler and bandwidth allocation settings are reset to the ETS default values (all priorities are in the same ETS priority group and bandwidth is allocated equally to each priority). If an error occurs when a port receives a peer's ETS configuration, the port's configuration is reset to the previously configured ETS output policy. If no ETS output policy was previously applied, the port is reset to the default ETS parameters. Related Commands scheduler bandwidth-percentage Schedule priority traffic in port queues. Bandwidth percentage allocated to priority traffic in port queues. scheduler Configure the method used to schedule priority traffic in port queues. Syntax scheduler value 170 | Data Center Bridging