Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 144

www.dell.com | support.dell.com reload-type Reload the system using the specified start-up mode. Syntax Parameters reload-type [normal | jump-start auto-save [enable | disable] dhcp-timeout {minutes} config-download [enable | disable]] normal jump-start dhcp-timeout config-download auto-save Enable the normal reload type. The system retrieves the FTOS image and start-up configuration files from the flash. Enable the BMP reload type. The system acts as a DHCP client and downloads the FTOS image and configuration and boot files from a specified DHCP server. Set the amount of time the system waits for a DHCP server response before reverting to normal reload type. Range: 1-50 minutes Default: infinity The default time is infinity; if no time is set, the system continues to wait unless the stop jump-start command is given. Note: Dell Force10 recommends setting the value to 2 or higher. Specify if the system should download a configuration file from the DHCP server or use the start-up configuration files from the flash. Enable: Download the configuration files from the server. Disable: Use the local start-up configuration files. Configure the auto save option for the downloaded configuration file. Defaults jump-start Command Modes EXEC Privilege Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module show reload-type Display the reload type currently configured on the system. Syntax Command Modes show reload-type EXEC Privilege Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module show boot jumpstart Display the jumpstart status at any instant. Syntax show boot jumpstart Command Modes EXEC Privilege 144 | Bare Metal Provisioning