Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 313
show ip management-route, Field, Description, Lines
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 313 highlights
Table 15-7. show ip interface Command Example Items (continued) Lines IP MTU is... Inbound access... Proxy ARP... Split horizon... Poison Reverse... ICMP redirects... ICMP unreachables... Description Displays IP MTU value. Displays the name of the any configured incoming access list. If none is configured, the phrase "not set" is displayed. States whether proxy ARP is enabled on the interface. States whether split horizon for RIP is enabled on the interface. States whether poison for RIP is enabled on the interface States if ICMP redirects are sent. States if ICMP unreachable messages are sent. Figure 15-14. show ip interface brief Command Example (Partial) FTOS#show ip int brief Interface IP-Address TenGigabitEthernet 0/1 unassigned TenGigabitEthernet 0/2 unassigned TenGigabitEthernet 0/3 unassigned TenGigabitEthernet 0/4 unassigned TenGigabitEthernet 0/5 unassigned TenGigabitEthernet 0/6 unassigned TenGigabitEthernet 0/7 unassigned TenGigabitEthernet 0/8 unassigned TenGigabitEthernet 0/9 unassigned OK? Method Status NO None up YES None up YES None up NO None up NO None up NO None up NO None up NO None up NO None up Protocol down up up down down down down down down Table 15-8. show ip interface brief Column Headings Field Interface IP-Address Ok? Method Status Protocol Description Displays type of interface and the associated slot and port number. Displays the IP address for the interface, if configured. Indicates if the hardware is functioning properly. Displays Manual if the configuration is read from the saved configuration. States whether the interface is enabled (up) or disabled (administratively down). States whether IP is enabled (up) or disabled (down) on the interface. show ip management-route View the IP addresses assigned to the Management interface. Syntax show ip management-route [all | connected | summary | static] Parameters all connected (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all Management interfaces on the switch. (OPTIONAL) Enter the keyword connected to view only routes directly connected to the Management interface. IPv4 Routing | 313