Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 604
show logging driverlog stack-unit, terminal monitor,
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 604 highlights
www.dell.com | support.dell.com Figure 31-14. show logging history Command Example FTOS#show logging history Syslog History Table: 1 maximum table entries, saving level warnings or higher SNMP notifications not Enabled May 22 08:53:09: %STKUNIT0-M:CP %SEC-3-AUTHENTICATION_ENABLE_SUCCESS: Enable password authentication success on vty0 ( 10.11.68.22 ) FTOS# show logging driverlog stack-unit Display the driver log for the specified stack member. Syntax show logging driverlog stack-unit unit# Parameters stack-unit unit# Enter the keyword stack-unit followed by the stack member ID of the switch for which you want to display the driver log. Range: 0 to 1 Defaults none Command Modes EXEC EXEC Privilege Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module This command displays internal software driver information, which may be useful during troubleshooting switch initialization errors, such as a downed Port-Pipe. terminal monitor Configure the FTOS to display messages on the monitor/terminal. Syntax terminal monitor To return to default settings, use the terminal no monitor command. Defaults Disabled. Command Modes EXEC EXEC Privilege Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Related Commands logging monitor Sets the logging parameters on the monitor/terminal. 604 | Simple Network Management Protocol (SNMP) and Syslog