Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 575
sflow polling-interval Interface, sflow sample-rate Global
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 575 highlights
sflow polling-interval (Interface) Set the sFlow polling interval at an interface (overrides the global-level setting.) Syntax sflow polling-interval interval value To return to the default, use the no sflow polling-interval interval command. Parameters interval value Enter the interval value in seconds. Range: 15 to 86400 seconds Default: The global counter polling interval Defaults The same value as the current global default counter polling interval. Command Modes INTERFACE Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module This command sets the counter polling interval for an interface. Related Commands sflow polling-interval (Global) Globally set the polling interval sflow sample-rate (Global) Change the global default sampling rate. Syntax sflow sample-rate value To return to the default sampling rate, use the no sflow sample-rate command. Parameters value Enter the sampling rate value. Range: 256 to 8388608 packets Enter values in powers of 2 only, for example 4096, 8192, 16384 etc. Default: 32768 packets Defaults Command Modes 32768 CONFIGURATION Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Sample-rate is the average number of packets skipped before the sample is taken. This command changes the global default sampling rate. You can configure an interface to use a different sampling rate than the global sampling rate. If the value entered is not a correct power of 2, the command generates an error message with the previous and next power of 2 value. Select one of these two packet numbers and re-enter the command. sFlow | 575