Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 148

www.dell.com | support.dell.com cam-acl (Configuration) Select the default CAM allocation settings or reconfigure new CAM allocation for Layer 2, IPv4 and IPv6 ACLs, Layer 2 and Layer 3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address validation for DHCP, Ethernet Connectivity Fault Management (CFM) ACLs, and Policy-based Routing (PBR). Syntax cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number l2qos number l2pt number ipmacacl number [vman-qos | vman-qos-dual- number | vman-qos-dual-fp number] ipv4pbr number} ecfmacl number fcoeacl number iscsioptacl number Parameters default l2acl number ipv4acl number ipv6acl number, ipv4qos number l2qos number, l2pt number ipmacacl number ecfmacl number [vman-qos | vman--qos-dual number | vman-qos-dual-fp number] ipv4pbr number Use the default CAM profile settings, and set the CAM as follows. • L3 ACL (ipv4acl): 2 • L2 ACL(l2acl): 2 • IPv6 L3 ACL(ipv6Acl):0 • L3 QoS (ipv4qos): 2 • L2 QOS(L2Qos): 1 • L2PT (L2PT): 0 • MAC ACL (IpMacAcl): 0 • VmanDualQos: 0 • EcfmAcl: 0 • FcoeAcl: 4 • iscsiOptAcl: 2 Allocate space to each CAM region. Enter the CAM profile name followed by the amount of CAM space to be allotted. The total space allocated must equal 13. The range for ipv4acl is 1 to 4. The ipv6acl range must be a factor of 2. The vman-qos-dual-fp number must be entered as a multiple of 4. Command Modes CONFIGURATION Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system for the new settings to take effect. The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and these cannot be reallocated. The ipv4acl profile range is 1-4. When configuring space for IPv6 ACLs, the total number of Blocks must equal 13. On the MXL 10/40GbE Switch IO Module, there can be only one odd number of Blocks in the CLI configuration; the other Blocks must be in factors of two. For example, a CLI configuration of 5+4+2+1+1 Blocks is not supported; a configuration of 6+4+2+1 Blocks is supported. Ranges for the CAM profiles are 1-10, except for the ipv6acl profile which is 0-10. The ipv6acl allocation must be a factor of two (2, 4, 6, 8, 10). 148 | Content Addressable Memory (CAM)