Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 53

Parameter host ip-address count datagram size timeout source tos df-bit validate-reply pattern pattern sweep-min-size sweep-max-size (OPTIONAL) Enter the host name of the devices to which you are testing connectivity. (OPTIONAL) Enter the IPv4 address of the device to which you are testing connectivity. The address must be in the dotted decimal format. Enter the number of echo packets to be sent. number: 1- 2147483647 Continuous: transmit echo request continuously Default: 5 Enter the ICMP datagram size. Range: 36 - 15360 bytes Default: 100 Enter the interval to wait for an echo reply before timing out. Range: 0 -3600 seconds Default: 2 seconds Enter the IPv4 source ip address or the source interface. • Enter the IP address in A.B.C.D format • For a Port Channel interface, enter the keyword port-channel followed by a number: Range: 1-128 • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. Enter the type of service required. Range: 0-255 Default: 0 Enter Y or N for the don't fragment bit in IPv4 header • N: Do not set the don't fragment bit • Y: Do set don't fragment bit Default is No. Enter Y or N for reply validation. • N: Do not validate reply data • Y: Do validate reply data Default is No. Enter the IPv4 data pattern. Range: 0-FFFF Default: 0xABCD Enter the minimum size of datagram in sweep range. Range: 52-15359 bytes Enter the maximum size of datagram in sweep range. Range: 53-15359 bytes Control and Monitoring | 53