Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 458
tc-flush-standard, vlan bridge-priority
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 458 highlights
www.dell.com | support.dell.com tc-flush-standard Enable the MAC address flushing upon receiving every topology change notification. Syntax tc-flush-standard To disable, use the no tc-flush-standard command. Defaults Disabled Command Modes CONFIGURATION Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information By default FTOS implements an optimized flush mechanism for PVST+. This helps in flushing the MAC addresses only when necessary (and less often) allowing for faster convergence during topology changes. However, if a standards-based flush mechanism is needed, this knob command can be turned on to enable flushing MAC addresses upon receiving every topology change notification. vlan bridge-priority Set the PVST+ bridge-priority for a VLAN or a set of VLANs. Syntax vlan bridge-priority value To return to the default value, enter no vlan bridge-priority command. Parameters vlan vlan-range bridge-priority value Enter the keyword vlan followed by the VLAN number(s). Range: 1 to 4094 Enter the keyword bridge-priority followed by the bridge priority value in increments of 4096. Range: 0 to 61440 Default: 32768 Defaults 32768 Command Modes CONFIGURATION (conf-pvst) Command History Related Commands Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module vlan forward-delay vlan hello-time vlan max-age show spanning-tree pvst Change the time interval before FTOS transitions to the forwarding state Change the time interval between BPDUs Change the time interval before PVST+ refreshes Display the PVST+ configuration 458 | Per-VLAN Spanning Tree Plus (PVST+)