Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 465
service-class bandwidth-percentage
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 465 highlights
Table 25-1. Default dot1p to Queue Mapping (continued) dot1p 3 4 5 6 7 Queue ID 1 2 3 3 3 Command Modes INTERFACE CONFIGURATION Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information Enter this command to honor all incoming 802.1p markings, on incoming switched traffic, on the interface. By default, this facility is not enabled (that is, the 802.1p markings on incoming traffic are not honored). This command can be applied on both physical interfaces and port channels. When you set the service-class dynamic for a port channel, the physical interfaces assigned to the port channel are automatically configured; you cannot assign the service-class dynamic command to individual interfaces in a port channel. On the MXL Switch, all traffic is by default mapped to the same queue, Queue 0. If you honor dot1p on ingress, then you can create service classes based the queueing strategy using the command service-class dynamic dot1p from INTERFACE mode. You may apply this queuing strategy to all interfaces by entering this command from CONFIGURATION mode. • All dot1p traffic is mapped to Queue 0 unless service-class dynamic dot1p is enabled on an interface or globally. • Layer 2 or Layer 3 service policies supercede dot1p service classes. service-class bandwidth-percentage Specify a minimum bandwidth for queues Syntax Parameters service-class bandwidth-percentage queue0 number queue1 number queue2 number queue3 number number Enter the bandwidth-weight. The value must be a power of 2. Range 1-100. Defaults none Command Modes CONFIGURATION Quality of Service (QoS) | 465