Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 493

Parameters interface database events trigger (OPTIONAL) Enter the interface type and ID as one of the following: • For a Port Channel interface, enter the keyword port-channel followed by a number: Range: 1-128 • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter the keyword database to display messages when there is a change to the RIP database. (OPTIONAL) Enter the keyword events to debug only RIP protocol changes. (OPTIONAL) Enter the keyword trigger to debug only RIP trigger extensions. Command Modes EXEC Privilege Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module default-information originate Generate a default route for the RIP traffic. Syntax default-information originate [always] [metric metric-value] [route-map map-name] To return to the default values, use the no default-information originate command. Parameters always metric metric-value route-map map-name (OPTIONAL) Enter the keyword always to enable the switch software to always advertise the default route. (OPTIONAL) Enter the keyword metric followed by a number as the metric value. Range: 1 to 16 Default: 1 (OPTIONAL) Enter the keyword route-map followed by the name of a configured route-map. Defaults Disabled metric: 1 Command Modes ROUTER RIP Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage The default route must be present in the switch routing table for the default-information originate Information command to take effect. Routing Information Protocol (RIP) | 493