Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 202
ip dhcp snooping vlan, ip dhcp relay, show ip dhcp snooping
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 202 highlights
www.dell.com | support.dell.com 1 Use the command cam-acl l2acl from CONFIGURATION mode 2 Save the running-config to the startup-config 3 Reload the system. ip dhcp snooping vlan Enable DHCP snooping on one or more VLANs. Syntax [no] ip dhcp snooping vlan name Parameters name Enter the name of a VLAN on which to enable DHCP Snooping. Command Modes CONFIGURATION Default Disabled Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage When enabled the system begins creating entries in the binding table for the specified VLAN(s). Note Information that learning only happens if there is a trusted port in the VLAN. Related Commands ip dhcp snooping trust Configures an interface as trusted. ip dhcp relay Enable Option 82. Syntax Parameters ip dhcp relay information-option [remote-id | trust-downstream] remote-id trust-downstream Configure the system to enable remote-id string in Option 82. Configure the system to trust Option 82 when it is received from the previous-hop router. Command Modes CONFIGURATION Default Disabled Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module show ip dhcp snooping Display the contents of the DHCP binding table or display the interfaces configured with IP source guard. Syntax show ip dhcp snooping [binding | source-address-validation] 202 | Dynamic Host Configuration Protocol (DHCP)