Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 44

www.dell.com | support.dell.com Example Figure 4-4. do Command Example FTOS(conf-if-te-5/0)#do clear counters Clear counters on all interfaces [confirm] FTOS(conf-if-te-5/0)# FTOS(conf-if-te-5/0)#do clear logging Clear logging buffer [confirm] FTOS(conf-if-te-5/0)# FTOS(conf-if-te-5/0)#do reload System configuration has been modified. Save? [yes/no]: n Proceed with reload [confirm yes/no]: n FTOS(conf-if-te-5/0)# enable Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you may need to enter a password. Syntax enable [level] Parameters level (OPTIONAL) Enter a number for a privilege level of FTOS. Range: 0 to 15. Default: 15 Defaults 15 Command Modes EXEC Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information Users entering EXEC Privilege mode or any other configured privilege level can access configuration commands. To protect against unauthorized access, use the enable password command to configure a password for the enable command at a specific privilege level. If no privilege level is specified, the default is privilege level 15. Related Commands enable password Configures a password for the enable command and to access a privilege level. enable optic-info-update interval Enable polling intervals of optical information updates for SNMP. Syntax enable optical-info-update interval seconds To disable optical power information updates, use the no enable optical-info-update interval command. Parameters interval seconds Enter the keyword interval followed by the polling interval in seconds. Range: 120 to 6000 seconds Default: 300 seconds (5 minutes) Defaults Disabled 44 | Control and Monitoring