Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 286
UDP Broadcast, Important Points to Remember, debug ip udp-helper
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 286 highlights
www.dell.com | support.dell.com UDP Broadcast The user datagram protocol (UDP) broadcast feature is a software-based method to forward low throughput (not to exceed 200 pps) IP/UDP broadcast traffic arriving on a physical or VLAN interface. Important Points to Remember • Routing information protocol (RIP) is not supported with the UDP broadcast feature. • If this feature is configured on an interface using ip udp-helper udp-port, the ip directed-broadcast command becomes ineffective on that interface. • The existing command show interface has been modified to display the configured broadcast address. The commands for UDP Broadcast are: • debug ip udp-helper • ip udp-broadcast-address • ip udp-helper udp-port • show ip udp-helper debug ip udp-helper Enable UDP debug and display the debug information on a console. Syntax debug ip udp-helper To disable debug information, use the no debug ip udp-helper command. Defaults Debug disabled Command Modes EXEC EXEC Privilege Example Figure 14-45. Debug Output Command Example FTOS#debug ip udp-helper UDP helper debugging is on 01:20:22: Pkt rcvd on TenGig 5/0 with IP DA (0xffffffff) will be sent on TenGig 5/1 TenGig 5/2 Vlan 3 01:44:54: Pkt rcvd on TenGig 7/0 is handed over for DHCP processing. Command History Related Commands Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module ip udp-broadcast-address ip udp-helper udp-port show ip udp-helper Configures a UDP IP address for broadcast Enables the UDP broadcast feature on an interface. Displays the configured UDP helper(s) on all interfaces. 286 | Interfaces