Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 360
multiplier, protocol lldp Configuration, protocol lldp Interface
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 360 highlights
www.dell.com | support.dell.com Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Related Commands protocol lldp (Configuration) show lldp neighbors Enables LLDP globally. Displays the LLDP neighbors multiplier Set the number of consecutive misses before LLDP declares the interface dead. Syntax multiplier integer To return to the default, use the no multiplier integer command. Parameters integer Enter the number of consecutive misses before the LLDP declares the interface dead. Range: 2 - 10 Defaults 4 x hello Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module protocol lldp (Configuration) Enable LLDP globally on the switch. Syntax protocol lldp To disable LLDP globally on the chassis, use the no protocol lldp command. Defaults Disabled Command Modes CONFIGURATION (conf-lldp) Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module protocol lldp (Interface) Enter the LLDP protocol in the INTERFACE mode. Syntax [no] protocol lldp To return to the global LLDP configuration mode, use the no protocol lldp command from the Interface mode. Defaults LLDP is not enabled on the interface. 360 | Link Layer Discovery Protocol (LLDP)