Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 290
arp learn-enable
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 290 highlights
www.dell.com | support.dell.com • show ip management-route • show ip protocols • show ip route • show ip route list • show ip route summary • show ip traffic • show tcp statistics arp Use the address resolution protocol (ARP) to associate an IP address with a MAC address in the switch. Syntax arp ip-address mac-address interface To remove an ARP address, use the no arp ip-address command. Parameters ip-address mac-address interface Enter an IP address in dotted decimal format. Enter a MAC address in nnnn.nnnn.nnnn format. Enter the following keywords and slot/port or number information: • For the Management interface, enter the keyword ManagementEthernet followed by the slot/port information. The slot range is 0-1 and the port range is 0. • For a Port Channel interface, enter the keyword port-channel followed by a number: Range: 1-128 • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage You cannot use Class D or Class E IP addresses or zero IP address (0.0.0.0) when creating a static Information ARP. Zero MAC addresses (00:00:00:00:00:00) are also invalid. Related Commands clear arp-cache show arp Clears dynamic ARP entries from the ARP table. Displays the ARP table. arp learn-enable Enable ARP learning via Gratuitous ARP. Syntax arp learn-enable 290 | IPv4 Routing