Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 248
interface range macro define, define interface-range macro, ommand Example
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 248 highlights
www.dell.com | support.dell.com interface range macro (define) Defines a macro for an interface range and then saves the macro in the running configuration. Syntax define interface range macro name interface , interface , ... Parameters name interface , interface ,... Enter up to 16 characters for the macro name. Enter the interface keyword (see below) and one of the interfaces slot/port, port-channel or VLAN numbers. Select the range of interfaces for bulk configuration. You can enter up to six comma separated ranges-spaces are not required between the commas. Comma-separated ranges can include VLANs, port-channels and physical interfaces. Slot/Port information must contain a space before and after the dash. For example, interface range tengigabitethernet 0/1 - 5 is valid; interface range tengigabitethernet 0/1-5 is not valid. • For a Port Channel interface, enter the keyword port-channel followed by a number: Range: 1-128 • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Defaults none Command Modes CONFIGURATION Command History Example Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Figure 14-17. define interface-range macro Command Example FTOS(conf)# define interface-range test tengigabitethernet 0/0 - 3 , tengigabitethernet 5/0 - 47 , tengigabitethernet 13/0 - 89 FTOS# show running-config | grep define define interface-range test tengigabitethernet 0/0 - 3 , tengigabitethernet 5/0 47 , tengigabitethernet 13/0 - 89 FTOS(conf)#interface range macro test FTOS(conf-if-range-te-0/0-3,tengig-5/0-47,tengig-13/0-89)# Usage Figure 14-17 is an example of how to define an interface range macro named test. To display the macro Information definition, execute the show running-config command. Related Commands interface range interface range macro name Configures a range of command (bulk configuration) Runs an interface range macro. 248 | Interfaces