Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 361

Command Modes INTERFACE (conf-if-interface-lldp) Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage You must enable LLDP globally from CONFIGURATION mode before you can configure it on an Information interface. This command places you in LLDP mode on the interface; it does not enable the protocol. When you enter the LLDP protocol in the Interface context, it overrides global configurations. When you execute the no protocol lldp from INTERFACE mode, interfaces begin to inherit the configuration from global LLDP CONFIGURATION mode. show lldp neighbors Display LLDP neighbor information for all interfaces or a specified interface. Syntax show lldp neighbors [interface] [detail] Parameters interface detail (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 10-Gigabit Ethernet interface, enter the keyword tenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. (OPTIONAL) Enter the keyword detail to display all the TLV information, timers, and LLDP tx and rx counters. Defaults none Command Modes EXEC Privilege Command History Example Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Figure 19-1. show lldp neighbors Command Example R1(conf-if-te-1/31)#do show lldp neighbors Loc PortID Rem Host Name Rem Port Id Rem Chassis Id TenGig 1/21 R2 TenGig 1/31 R3 TenGigabitEthernet 2/11 00:01:e8:06:95:3e TenGigabitEthernet 3/11 00:01:e8:09:c2:4a Usage Omitting the keyword detail displays only the remote chassis ID, Port ID, and Dead Interval. Information show lldp statistics Display the LLDP statistical information. Syntax show lldp statistics Defaults none Link Layer Discovery Protocol (LLDP) | 361