Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 257
the Tagged Hybrid Interface, Uncon the hybrid port, Example, Display, Related
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 257 highlights
Example Figure 14-24. Display the Tagged Hybrid Interface FTOS(conf)#interface tengig 0/20 FTOS(conf-if-te-0/20)#no shut FTOS(conf-if-te-0/20)#portmode hybrid FTOS(conf-if-te-0/20#sw FTOS(conf-if-te-0/20)#int vlan 10 FTOS(conf-if-vl-10)#int tengig 0/20 FTOS(conf-if-vl-20)# untag tengig 0/20 FTOS (conf-if-vl-20)# FTOS(conf)#do show interfaces switchport tengigabitethernet 3/20 Codes: U - Untagged, T - Tagged x - Dot1x untagged, X - Dot1x tagged G - GVRP tagged, M - Trunk, H - VSN tagged i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged Name: TenGigabitEthernet 3/20 802.1QTagged: Hybrid Vlan membership: Q Vlans U 20 T 10 Native VlanId: 20. FTOS(conf)# Figure 14-25 is an example of unconfiguration of the hybrid port using the no portmode hybrid command. Note: You must remove all other configurations on the port before you can remove the hybrid configuration from the port. Example Figure 14-25. Unconfigure the hybrid port FTOS(conf-if-vl-20)#interface vlan 10 FTOS(conf-if-vl-10)#no untagged tengig 0/20 FTOS(conf-if-vl-10)#interface vlan 20 FTOS(conf-if-vl-20)#no tagged tengig 0/20 FTOS(conf-if-vl-20)#interface tengig 0/20 FTOS(conf-if-te-0/20)#no portmode hybrid FTOS(conf-if-vl-20)# Related Commands show interfaces switchport vlan-stack trunk Displays the configuration of switchport (Layer 2) interfaces on the switch. Specifies an interface as a trunk port to the Stackable VLAN network. Interfaces | 257