Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 425

show ip ospf neighbor Display the OSPF neighbors connected to the local router. Syntax show ip ospf process-id neighbor Parameters process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Command Modes EXEC Privilege Command History Example Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Figure 21-15. show ip ospf process-id neighbor Command Example FTOS#show ip ospf 34 neighbor Neighbor ID Pri State Dead Time Address 20.20.20.7 1 FULL/DR 00:00:32 182.10.10.3 192.10.10.2 1 FULL/DR 00:00:37 192.10.10.2 20.20.20.1 1 FULL/DROTHER00:00:36 192.10.10.4 FTOS# Interface Area TenGig 0/0 0.0.0.2 TenGig 0/1 0.0.0.1 TenGig 0/1 0.0.0.1 Table 21-11. show ip ospf process-id neighbor Command Description Row Heading Neighbor ID Pri State Dead Time Address Interface Area Description Displays the neighbor router ID. Displays the priority assigned neighbor. Displays the OSPF state of the neighbor. Displays the expected time until FTOS declares the neighbor dead. Displays the IP address of the neighbor. Displays the interface type slot/port information. Displays the neighbor's area (process ID). show ip ospf routes Display routes as calculated by OSPF and stored in OSPF RIB. Syntax show ip ospf process-id routes Parameters process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Defaults Command Modes none EXEC EXEC Privilege Open Shortest Path First (OSPFv2) | 425