Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 652
upstream, uplink-state-group Command Example
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 652 highlights
www.dell.com | support.dell.com Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage After you enter the command, you enter Uplink-State-Group Configuration mode to assign upstream Information and downstream interfaces to the group. An uplink-state group is considered to be operationally UP if at least one upstream interface in the group is in the Link-Up state. An Uplink-State group is considered to be operationally DOWN if no upstream interfaces in the group are in the link-up state. No uplink-state tracking is performed when a group is disabled or in an operationally down state. Related Commands show running-config uplink-state-group show uplink-state-group Displays the current configuration of one or more uplink-state groups. Displays status information on a specified uplink-state group or all groups. Example Figure 36-4. uplink-state-group Command Example FTOS(conf)#uplink-state-group 16 FTOS(conf)# 02:23:17: %STKUNIT0-M:CP %IFMGR-5-ASTATE_UP: Changed uplink state group Admin state to up: Group 16 upstream Syntax Assign a port or port-channel to the uplink-state group as an upstream interface. upstream interface To delete an upstream interface, use the no upstream interface command. Parameters interface Enter one of the following interface types: 10-Gigabit Ethernet: tengigabitethernet {slot/port | slot/port-range} 40-Gigabit Ethernet: fortygigabitethernet {slot/port |slot/port-range} Port channel: port-channel {1-512 | port-channel-range} Where port-range and port-channel-range specify a range of ports separated by a dash (-) and/or individual ports/port channels in any order; for example: tengigabitethernet 1/1-2,5,9,11-12 port-channel 1-3,5 A comma is required to separate each port and port-range entry. Defaults none Command Modes UPLINK-STATE-GROUP Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module You can assign physical port or port-channel interfaces to an uplink-state group. You can assign an interface to only one uplink-state group. You must configure each interface assigned to an uplink-state group as either an upstream or downstream interface, but not both. 652 | Uplink Failure Detection (UFD)