Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 332

www.dell.com | support.dell.com Related Commands show lacp Displays the LACP configuration debug lacp Debug LACP (configuration, events etc.) Syntax debug lacp [config | events | pdu [in | out | [interface [in | out]]]] To disable LACP debugging, use the no debug lacp [config | events | pdu [in | out | [interface [in | out]]]] command. Parameters config events pdu in | out interface in | out (OPTIONAL) Enter the keyword config to debug the LACP configuration. (OPTIONAL) Enter the keyword events to debug LACP event information. (OPTIONAL) Enter the keyword pdu to debug LACP Protocol Data Unit information. Optionally, enter an in or out parameter to: • Receive enter in • Transmit enter out Enter the following keywords and slot/port or number information: • For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Optionally, enter an in or out parameter: • Receive enter in • Transmit enter out Defaults none Command Modes EXEC EXEC Privilege Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module lacp long-timeout Configure a long timeout period (30 seconds) for an LACP session. Syntax lacp long-timeout To reset the timeout period to a short timeout (1 second), use the no lacp long-timeout command. Defaults 1 second Command Modes INTERFACE (conf-if-po-number) Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module 332 | Link Aggregation Control Protocol (LACP)