Netgear XSM4324FS User Manual - Page 126

M4300 Intelligent Edge Series Fully Managed Stackable Switches Table 44. Nonconfigurable fields on the Advanced PoE Configuration page (continued) Field Class Output Voltage Output Current Output Power Status Fault Status Description The Class defines the range of power a PD is drawing from the system. Class definitions: 0 - 0.44-12.95 (watts) 1 - 0.44-3.83 (watts) 2 - 0.44-6.48 (watts) 3 - 0.44-12.95 (watts) 4 - 0.44-25.5 (watts) Current voltage being delivered to device in volts. Current being delivered to device in mA. Current power being delivered to device in Watts. The status is the operational status of the port PD detection. • Disabled. No power being delivered. • DeliveringPower. Power is being drawn by device. • Fault. Indicates a problem with the port. • Test. The port is in test mode. • otherFault. The port is idle due to error condition. • Searching. The port is not in one of the above states. Describes the error description when the PSE port is in fault status. • No Error. The PSE port is not in any error state. • MPS Absent. The PSE port has detected an absence of main power supply. • Short. The PSE port has detected a short circuit condition. • Overload.The PD connected to the PSE port tried to provide more power than it is permissible by the hardware. • Power Denied. The PSE port was denied power because of shortage of power or due to administrative action. Configure PoE Power Settings To configure PoE power settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. Configure System Information 126 User Manual