Netgear XSM4324FS User Manual - Page 542

M4300 Intelligent Edge Series Fully Managed Stackable Switches Configure Access Rule Settings for the Access Control Profile After you set up an access control profile, you can configure and apply an access control rules. However, to do this, the access control profile must be in a deactivated state. AFter you added the access control rule, you can reactivate the access control profile. To configure the access rule settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Security > Access > Access Control > Access Rule Configuration. 5. From the Rule Type menu, select whether the traffic is permitted (Permit) or denied (Deny) when the a rule match occurs. 6. From the Service Type menu, select the management method to which the policy is restricted: • TELNET • TFTP • HTTP • Secure HTTP (SSL) • SNMP • Secure Telnet (SSH) 7. In the Source IP Address field, enter the source IP address, that is, the IP address from which management traffic originates. 8. In Mask field, enter the mask for the source IP address. 9. From the Priority menu, select the priority for the rule. Manage Switch Security 542 User Manual