Netgear XSM4324FS User Manual - Page 454

M4300 Intelligent Edge Series Fully Managed Stackable Switches Configure the IPv6 PIM Interface To configure the IPv6 PIM interface: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Routing> IPv6 Multicast > IPv6 PIM > Interface Configuration. 5. Use one of the following methods to select an interface: • In the Go To Interface field, enter the interface in the unit/slot/port format and click on the Go button. • Next to the Interface column, select the check box for the interface that you want to configure. 6. In the Admin Mode field, select Enable or Disable. This sets the administrative status of PIM-SM in the router. The default is Disable. 7. In the Hello Interval field, enter the time in seconds between the transmission of PIM hello messages on this interface. The valid values are from 0 to 18000. The default value is 30. 8. In the Join/Prune Interval field, enter the frequency at which PIM Join/Prune messages are transmitted on this PIM interface. The valid values are from 0 to 18000. The default value is 60. 9. In the BSR Border field, select the Enable or Disable option to set the bootstrap router (BSR) border status on the selected interface. 10. Enter the DR Priority for the selected interface. The valid values are from 0 to 2147483647. The default value is 1. Configure Multicast Routing 454 User Manual