Netgear XSM4324FS User Manual - Page 184

M4300 Intelligent Edge Series Fully Managed Stackable Switches WARNING: If you select this button and confirm your selection on the next page, all VLAN configuration parameters are reset to their factory default values. 6. Confirm your selection. All VLANs, except for the default VLAN, are deleted. The factory default values are as follows: • All ports are assigned to the default VLAN of 1. • All ports are configured with a PVID of 1. • All ports are configured to an Acceptable Frame Types value of Admit All Frames. • All ports are configured with ingress filtering disabled. • All ports are configured to transmit only untagged frames. • GVRP is disabled on all ports and all dynamic entries are cleared. Configure an Internal VLAN The Internal VLAN section displays the allocation base and the allocation mode of internal VLAN. The internal VLAN is reserved by a port-based routing interface and invisible to the end user. Once these internal VLANs are allocated by the port-based routing interface, they cannot be assigned to a routing VLAN interface. To configure an internal VLAN: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. Configure Switching Information 184 User Manual