Netgear XSM4324FS User Manual - Page 573

M4300 Intelligent Edge Series Fully Managed Stackable Switches 7. If Invalid Packets is enabled, DHCP snooping application logs invalid packets on this interface. The factory default is Disable. 8. Use Rate Limit (pps) to specify rate limit value for DHCP snooping purposes. If the incoming rate of DHCP packets exceeds the value of this for consecutive burst interval seconds, the port is shut down. If this value is N/A, then burst interval has no meaning, hence it is disabled. The default value is N/A. It can be set to value -1, which means N/A. The range of rate limit is 0 to 300. 9. Use Burst Interval (secs) to specify the burst interval value for rate limiting purpose on this interface. If the rate limit is N/A, burst interval has no meaning and it is N/A. The default value is N/A. It can be set to -1, which means N/A. The range of Burst Interval is 1 to 15. 10. Click the Apply button. Your settings are saved. Configure a Static DHCP Snooping Binding To configure a static snooping binding: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Security > Control > DHCP Snooping > Binding Configuration. Manage Switch Security 573 User Manual