Netgear XSM4324FS User Manual - Page 72

M4300 Intelligent Edge Series Fully Managed Stackable Switches requesting order follows the lexicographical ordering of the entries in this table. The valid range is 1 to 3. The default value is 1. 9. Specify the NTP Version running on the server. The range is 1 to 4. The default value is 4. 10. Click the Add button. The SNTP server entry is added. 11. Repeat the previous steps to add additional SNTP servers. You can configure up to three SNTP servers. 12. Click the Apply button. Your settings are saved. 13. To change the settings, remove an SNTP server, or refresh the page, do the following: • Change the settings. To change the settings for an existing SNTP server, select the check box next to the configured server, enter new values in the available fields, and click the Apply button. Your settings are saved. • Remove an SNTP server. To remove an SNTP server entry, select the check box next to the configured server to remove, and then click the Delete button. The entry is removed, and the device is updated. • Refresh the page. To refresh the page, click the Refresh button. The SNTP Server Status table displays status information about the SNTP servers configured on your switch. The following table displays SNTP Server Status information. Table 21. SNTP Server Status Field Address Last Update Time Last Attempt Time Description All the existing server addresses. If no server configuration exists, a message saying No SNTP server exists flashes on the page. The local date and time (UTC) that the response from this server was used to update the system clock. The local date and time (UTC) that this SNTP server was last queried. Configure System Information 72 User Manual